This article was previously published under Q315249
For a Microsoft Windows 2000 version of this article, see 246243.
You may receive the following error:
STOP 0x0000009F DRIVER_POWER_STATE_FAILURE
This error occurs if drivers do not handle power state transition requests properly, usually during one of the following procedures:
Suspending or resuming from Standby mode
Suspending or resuming from hibernation
To resolve the error and prevent the error from recurring, update or remove the offending driver. This error can occur because of a device driver, but it can also occur because of a file system filter driver (for example, a driver that is installed by an antivirus, remote control, or backup program).
To isolate the driver that is causing the error, follow these steps:
Check to make sure that your computer and all installed devices are on the Hardware Compatibility List (HCL). You can view the HCL at the following Microsoft Web site:
Check for drivers that are not designed for use with Windows. You can use the Sigverif.exe tool to do this. For information about how to use the Sigverif tool, refer to the following article in the Microsoft Knowledge Base:
308514 HOW TO: Verify Unsigned Device Drivers in Windows XP
Check for driver updates that may be available for your hardware.
Update any software that uses filter drivers (for example, antivirus, remote control, and backup software).
Remove any non-critical devices and software to help isolate the device or software that is causing the error.
Install Windows in a new folder. Add drivers one by one, and restart the computer after each addition, to try to locate the driver that is causing the error.
Microsoft has confirmed that this is a problem in the Microsoft products that are listed at the beginning of this article.
For additional information about how to install Windows XP to a new folder, click the following article number to view the article in the Microsoft Knowledge Base: