XADM: The SMTP Connector Returns an Error Message When Invalid Characters Are Used

This article was previously published under Q316061
This article has been archived. It is offered "as is" and will no longer be updated.
SYMPTOMS
When you add an address space to an SMTP Connector in Exchange 2000 Server Service Pack 2 (SP2), you may receive the following error message:
The specified SMTP domain is not valid.
ID no: c103491e
Exchange System Manager
If you click OK, the Internet Address Space Properties dialog box of the SMTP Connector is displayed.
CAUSE
This issue can occur if the E-mail domain field contains an invalid character.

Earlier versions of Exchange 2000 do not verify that the E-mail domain field contains only valid characters. Exchange 2000 Server SP2 verifies that this field does not contain invalid characters to more closely conform to the Request for Comments (RFC) 821 document.
RESOLUTION
To resolve this issue, remove the invalid character from the E-mail domain field. Only the following ASCII characters are valid for the E-mail domain field:
  • Lowercase letters a through z
  • Uppercase letters A through Z
  • Digits 0 through 9
  • Underscore (_)
  • Dash or hyphen (-)
  • Apostrophe (')
NOTE: The parentheses () in the preceding text are not part of the allowed set of characters.
MORE INFORMATION
For additional information, click the article number below to view the article in the Microsoft Knowledge Base:
294736 XCON: When to Create SMTP Connectors in Exchange 2000
exch2kp2w
Properties

Article ID: 316061 - Last Review: 10/24/2013 09:19:31 - Revision: 5.3

  • Microsoft Exchange 2000 Server Service Pack 2
  • kbnosurvey kbarchive kberrmsg kbprb KB316061
Feedback