"HCW8095" error when you run the Hybrid Configuration Wizard

Note The Hybrid Configuration Wizard that's included in the Exchange Management Console in Microsoft Exchange Server 2010 is no longer supported. Therefore, you should no longer use the old Hybrid Configuration Wizard. Instead, use the Office 365 Hybrid Configuration Wizard that's available at http://aka.ms/HybridWizard. For more information, see Office 365 Hybrid Configuration Wizard for Exchange 2010.
PROBLEM
When you run the Hybrid Configuration Wizard, you receive the following error message:

HCW8095 = The federation trust isn't provisioned within your on-premises Exchange organization.
CAUSE
The federation trust has invalid settings that prevent the wizard from completing the hybrid configuration.
SOLUTION
To resolve this problem, follow these steps:
  1. Run the Hybrid Configuration Wizard again from http://aka.ms/HybridWizard. If the wizard successfully finishes, you don't have to do the remaining steps in this article. If the problem persists, go to step 2. 
  2. Remove the existing federation trust. To do this, connect to the on-premises Exchange Management Shell, and then run the following command:
    Get-FederationTrust | Remove-FederationTrust
  3. Run the Hybrid Configuration Wizard again.
MORE INFORMATION
Still need help? Go to the Office 365 Community website or the Exchange TechNet Forums.
Properties

Article ID: 3185377 - Last Review: 08/19/2016 23:16:00 - Revision: 4.0

Microsoft Exchange Online, Microsoft Exchange Server 2013 Enterprise, Microsoft Exchange Server 2013 Standard, Exchange Server 2016 Enterprise Edition, Exchange Server 2016 Standard Edition, Microsoft Exchange Server 2010 Enterprise, Microsoft Exchange Server 2010 Standard

  • o365022013 o365 o365a o365e o365m hybrid KB3185377
Feedback