This article describes the procedure that you follow to enable network Distributed Transaction Coordinator (DTC)
access in Microsoft Windows Server 2003. Note
The following procedure is for Windows Server 2003. It does not apply to Microsoft Windows 2000 Server.
By default, network DTC access is disabled on
the Windows Server 2003 products that are mentioned in the "Applies To" section. When you do not enable network DTC access on the server,
applications can only use transactions that stay on the local computer. For
example, transactions cannot flow from a local computer to a database that runs on a separate computer if network DTC access is disabled.
When network DTC access is disabled, clients that try to gain access to DTC on the server may receive the following error message:
error 0x8004D025 (XACT_E_PARTNER_NETWORK_TX_DISABLED)
For more information about how to configure DTC on a Windows Server 2003 cluster, click the following article number to view the article in the Microsoft Knowledge Base:
How to configure Microsoft Distributed Transaction Coordinator on a Windows Server 2003 cluster
Steps to enable network DTC access
- Click Start, point to
Control Panel, and then click Add or Remove
- Click Add/Remove Windows
- Select Application Server, and then click
- Select Enable network DTC access, and
then click OK.
- Click Next.
- Click Finish.
If you are running Windows Server 2003 Service Pack 1 (SP1), you must follow these additional steps:
comexp.msc, and then click
to open Component Services.
- Expand Component Services, expand Computers, right-click My Computer, and then click Properties.
- On the MSDTC tab, click Secuity Configuration under Transaction Configuration, click to select the Network DTC Access check box under Secuity Settings, and then click to select the following check boxes under Transaction Manager Communication:
- Allow Inbound
- Allow Outbound
- On Microsoft Cluster Server (MSCS) clusters, you cannot select Mutual Authentication Required. Therefore, click to select one of the following check boxes:
For more information about these options, click the following article number to view the article in the Microsoft Knowledge Base:
- Incoming Caller Authentication Required
- No Authentication Required
New functionality in the Distributed Transaction Coordinator service in Windows Server 2003 Service Pack 1 and in Windows XP Service Pack 2
- Make sure that the Logon Account is set to NTAUTHORITY\NetworkService.
- Click OK. A message box explains that the MS DTC Service will be stopped and restarted, and that all dependent services will also be stopped and restarted. Click Yes.
Note If this is a Majority Node Set (MNS) cluster, do not use the MNS resource as the storage device for MS DTC. MS DTC requires a storage resource such as a physical disk.
For more information about what is new in Microsoft COM+ 1.5, visit the following Microsoft Developer Network (MSDN) Web site:
Article ID: 817064 - Last Review: March 14, 2009 - Revision: 11.1
- Microsoft Windows Server 2003, Datacenter Edition (32-bit x86)
- Microsoft Windows Server 2003, Enterprise Edition (32-bit x86)
- Microsoft Windows Server 2003, Standard Edition (32-bit x86)
- Microsoft Windows Server 2003, Web Edition
- Microsoft Windows Small Business Server 2003 Premium Edition
- Microsoft Windows Small Business Server 2003 Standard Edition
- Microsoft Windows XP 64-Bit Edition Version 2003
|kberrmsg kbmgmtservices kbhowtomaster kbnetwork kbcomservices kbhowto KB817064|