Use the Netsh command-line tool to configure the IPv6 protocol instead of using the IPv6.exe utility

This article has been archived. It is offered "as is" and will no longer be updated.
Introduction
Microsoft recommends that users of Microsoft Windows XP-based computers (Service Pack 1 and later releases) use the Netsh command-line tool (Netsh.exe) to configure Internet Protocol version 6 (IPv6). Microsoft recommends that you use Netsh for IPv6 instead of using the IPv6.exe utility. Netsh for Interface IPv6 is included in the Networking Pack. You can use Netsh to query and configure IPv6 interfaces, address, caches, and routes.
More information
Netsh is a command-line scripting interface. You can use Netsh to configure and monitor Windows XP networking.

For more information about Netsh, see Windows XP Help and Support. To do so, click Start, click Help and Support, type using netsh in the Search box, and then press ENTER to view the topics.

For additional information about IPv6, visit the following Microsoft Web site: For additional information about the Advanced Networking Pack for Windows XP , click the following article number to view the article in the Microsoft Knowledge Base:
817778 Overview of the Advanced Networking Pack for Windows XP


For information about how to map Ipv6.exe commands to their netsh equivalents, visit the following Microsoft Web site:
Properties

Article ID: 828999 - Last Review: 01/11/2015 05:27:41 - Revision: 4.0

  • kbnosurvey kbarchive kbinfo kbprb KB828999
Feedback