You are currently offline, waiting for your internet to reconnect

"Logical Disk Manager" error messages when you use Disk Management to format a new hard-disk partition in Windows Server 2003

Support for Windows Server 2003 ended on July 14, 2015

Microsoft ended support for Windows Server 2003 on July 14, 2015. This change has affected your software updates and security options. Learn what this means for you and how to stay protected.

When you use the New Partition Wizard in Disk Management to create a new hard-disk partition on a Microsoft Windows Server 2003-based computer, and then you perform one or both of the following actions, you may receive an error message:
  • You try to format the new hard-disk partition.
  • You try to assign a drive letter to the new hard-disk partition.
In this scenario, you may receive one or both of the following error messages:
Logical Disk Manager: The path cannot be used for creating a drive path likely because the folder does not exist or is already a drive path to some other volume.
Logical Disk Manager: The format did not complete successfully.
Remote Storage temporarily opens an exclusive handle to the hard-disk partition immediately after it receives notification that a new hard-disk partition has been created. However, Disk Management tries to either format the new hard-disk partition or assign the drive letter at the same time that Remote Storage opens a handle to the new partition. Because of this timing problem, Disk Management cannot successfully open a handle to the new partition.
To work around this problem, use one of the following methods after you receive one or both of the error message that are described in the "Symptoms" section:
  • Try again to assign the drive letter to the new partition.
  • Try again to format the new partition.
Or, perform both of these methods again, as needed.

Note If you must perform these methods repeatedly, it may be useful to stop Remote Storage. To stop Remote Storage, follow these steps:
  1. Click Start, point to Programs, point to Administrative Tools, and then click Services.
  2. In the right pane, right-click Remote Storage Server, and then click Stop.
  3. Close the Services dialog box.
Microsoft has confirmed that this is a problem in the Microsoft products that are listed in the "Applies to" section.
For additional information about how to use Remote Storage in Windows Server 2003, click the following article number to view the article in the Microsoft Knowledge Base:
816588 How to use Remote Storage in Windows Server 2003

Article ID: 883100 - Last Review: 08/03/2004 22:11:07 - Revision: 1.3

  • Microsoft Windows Server 2003, Enterprise x64 Edition
  • Microsoft Windows Server 2003, Enterprise Edition (32-bit x86)
  • kbbug kbfix kbwinserv2003presp1fix KB883100