You are currently offline, waiting for your internet to reconnect

The health state of an incoming VPN connection may appear to be incorrect on a Windows Server 2008-based computer

This article has been archived. It is offered "as is" and will no longer be updated.
SYMPTOMS
The health state of an incoming virtual private network (VPN) connection may appear to be incorrect in the Routing and Remote Access snap-in on a Windows Server 2008-based computer.
MORE INFORMATION
You may experience this issue in several scenarios. The following sample scenarios may help you identify the issue.

Scenario 1

  • You are using a non-Network Access Protection (NAP) connection to connect to a Windows Server 2008-based Routing and Remote Access server from a client computer.
  • You are using Remote Access Quarantine service filters.
In this scenario, the status of the Routing and Remote Access client may be displayed incorrectly.

Scenario 2

  • You are using non-Protected Extensible Authentication Protocol (PEAP) authentication to connect to the Windows Server 2008-based Routing and Remote Access server.
  • You are using Network Policy Server (NPS) together with legacy Remote Access Quarantine service filters.
In this scenario, you expect the status of the Routing and Remote Access client to appear as Quarantine or as Restricted on the Windows Server 2008-based computer. Instead, the status of the client appears as Not NAP Capable. If you use the netsh command to see the status, the status appears as "Unknown."

Scenario 3

  • You are using PEAP authentication to connect to the Windows Server 2008-based Routing and Remote Access server.
  • On the client computer, you configure the incoming connection to match the NAP health policy.
  • The Remote Access Quarantine service is running on the Windows Server 2008-based computer.
In this scenario, the status of the Routing and Remote Access client may appear as Unrestricted on the Windows Server 2008-based computer.
STATUS
Microsoft has confirmed that this is a problem in the Microsoft products that are listed in the "Applies to" section.
Properties

Article ID: 947019 - Last Review: 01/16/2015 16:10:51 - Revision: 1.1

Windows Server 2008 Standard, Windows Server 2008 Enterprise, Windows Server 2008 Datacenter

  • kbnosurvey kbarchive kbtshoot kbbug KB947019
Feedback