A slide show does not continue to loop after all participants have left the meeting in Live Meeting 2007

This article has been archived. It is offered "as is" and will no longer be updated.
Symptoms
You create a continuously looping slide show in Microsoft Office Live Meeting 2007. The slide show stops running approximately five minutes after the last participant exits the meeting.

Note This behavior differs from the behavior in Live Meeting 2005 in which a slide show continues to run in a loop after the last participant exits the meeting. Typically, Live Meeting 2005 system administrators provide a meeting that contains a continuously looping slide show so that users can verify that they can install the Live Meeting console and that they can connect to Live Meeting successfully.
Cause
Live Meeting 2007 was changed to improve overall system performance and to help improve security. These changes effectively prevent a continuously looping slide show from working as it did in Live Meeting 2005.
Workaround
To work around this issue, use the dedicated test meeting to verify that the Live Meeting 2007 console is installed correctly and is working as expected. To join the test meeting, visit the following Live Meeting 2007 Web page:Note If you are prompted to download a newer version of Live Meeting 2007, click Yes, and then follow the instructions to install it.
lm2007 lm2k7 setup test trial trail configure cycle LM LMSC LMCC LM2007Rev YesPartner
Properties

Article ID: 961637 - Last Review: 01/14/2015 16:32:10 - Revision: 4.0


  • kbnosurvey kbarchive kbinstallation kbexpertisebeginner kbtshoot kbsurveynew kbprb vkbportal230 vkbportal107 vkbportal238 KB961637
Feedback