Article ID: 973490 - View products that this article applies to.
You can use Dynamic Distribution Group (DDG) in a Microsoft Exchange Server 2007 environment. You can create a DDG in Exchange Management Console (EMC) or in Exchange Management Shell (EMS). If the filter is complex, you must create the DDG in EMS. You can create the DDG by using the new-dynamicdistributiongroup command together with -RecipientFilter parameters. However, if you have more than one -and statement in a row, the RecipientFilter value is written as an invalid filter.
For example, you create a DDG that is named "testDDG" in EMS by using the following command:
Then, you locate the filter by using the EMC, or by using the following command:
After you run this command, the following filter is returned:
To obtain the preview recipient list, you run the following command together with the filter that you obtained in the previous step:
When you run this command, you do not receive the expected recipient list. Instead, you receive the following error message
You must provide a value expression on the right-hand side of the '-and' operator.
This issue occurs because the filter parser misses a required separator.
To resolve this problem, install Update Rollup 1 for Exchange 2007 Service Pack 2.
(https://support.microsoft.com/kb/971534/ )Description of Update Rollup 1 for Exchange Server Service Pack 2
Microsoft has confirmed that this is a problem in the Microsoft products that are listed in the "Applies to" section.
Article ID: 973490 - Last Review: November 19, 2009 - Revision: 1.0