FIX: SNACFG /DLURRETRYDELAY doesn't work with delay greater than 255 seconds

Symptoms

Consider the following scenario:

• You are running the command prompt utility SNACFG. (This utility is included with Microsoft Host Integration Server 2013.)

• You try to change the DLUR Retry timer by using the following command:
  
  SNACFG /DLURRETRYDELAY:<seconds>

In this scenario, the command works unless you try to use a delay value that is greater than 255 seconds. In that case, the value wraps. You cannot increase the delay to greater than 255 seconds.

Note This scenario works fine when you use SNA Manager.

Cause

This problem occurs because of an incorrect CAST of the value.

Resolution

Status

Microsoft has confirmed that this is a problem in the Microsoft products that are listed in the "Applies to" section.