For Microsoft Exchange Server 2013 with Service Pack 1 and later versions, you can increase the export buffer size. To do this, add the ExportBufferSizeOverrideKB
parameter to the MRSConfiguration
section of the MSExchangeMailboxReplication.exe.config file. This setting reduces the number of migration calls and reduces the time that's spent in network latency. The recommended maximum value for this setting is 7,500, and the minimum value is 512. However, note that if you change the value of the ExportBufferSizeOverrideKB
parameter, you should also change the DataImportTimeout
The following example shows the ExportBufferSizeOverrideKB
setting after it's been added to the configuration file:
OldItemAge = "366.00:00:00"
You must also set the DataImportTimeout
value in the MRSProxyConfiguration
section of the MSExchangeMailboxReplication.exe.config file to correspond to the minimum upload rate that you can sustain during the migration. For example:
7.5 MB/(60 seconds) = 131,072 bytes/second (for reference, 1,024 KB/s = 1 Megabit/s)
This means that you can never go lower than this rate. You can increase the DataImportTimeout
value a bit more than the computed minimum. The following example shows the DataImportTimeout
setting in the configuration file. In this example, it's set to 5 minutes. You can safely increase the value to 20 minutes.
This solution disables cross-forest downgrade moves between Exchange 2013 SP1 and later versions to Exchange 2010 servers.
To learn more about how to analyze mailbox migration performance, see Mailbox Migration Performance Analysis