How to configure the error limit in a Run Profile

Summary

Cause: Certain synchronization activities result in the creation of temporary error conditions that are eventually resolved once the synchronization has had the opportunity to finish running. In environments where extremely large numbers of objects are being processed the number of these errors may exceed the default error limit of 5000 causing the synchronization process to terminate before it has finished processing all objects.

More Information

The synchronization services returns a stopped-error-limit error message.

The most common cause of this situation is an accumulation of "exported-change-not-reimported" errors.


You can increase the error limit to a sufficient value so that synchronization can finish processing all objects before the error limit is reached. Given the opportunity to finish, the synchronization process will eventually resolve the temporary error conditions. The error limit is configured by adding the ErrorLimit (REG_DWORD) entry to the following registry subkey:

If you are using MIIS / ILM / IIFP
HKEY_LOCAL_MACHINE\System\CurrentControlSet\Services\miisserver\Parameters


If you are using FIM 2010
HKEY_LOCAL_MACHINE\System\CurrentControlSet\Services\FIMSynchronizationService\Parameters

The value is an integer in the range of 0-100000.
• Value set to 0 = Error limit set to 100000
• Value in the range of 1-99999 = Error limit set to value
• Value set to 100000 = Error limit set to 100000
• Value set greater than 100000 = Error limit set to 100000
• No key present = Default error limit set to 5000
Note The miiserver service must be restarted after modifying this registry key.

 


속성

문서 ID: 2387673 - 마지막 검토: 2010. 9. 21. - 수정: 1

피드백