- You remove a network interface from the remote access server.
- You re-add that network interface to the remote access server.
Method 1: Manually Add the Default Route for the InterfaceUse the Route Add command to manually add the default route for the network interface that you added. To do so:
- Click Start, click Run, type cmd in the Open box, and then click OK.
- Type route print, and then press ENTER to view the routing table. Note the interface number of the network interface that you re-added.
- Type the following command, and then press ENTERroute add 0.0.0.0 mask 0.0.0.0 gateway IP metric 30 if Interface numberwhere gateway IP is the IP address of the default gateway for this interface, and where Interface number is the number that corresponds to the network interface that you added (for example, 2). For example, if your default gateway IP address is 192.168.1.1 and the interface number is 2, type the following command, and then press ENTER:route add 0.0.0.0 mask 0.0.0.0 192.168.1.1 metric 30 if 2
- Type route print to verify that the new default route appears in the routing table.
- Close the command prompt.
Method 2: Restart the Remote Access ServiceRestart the remote access service. The default route for the re-added network interface is added to the Windows routing table. To do so:
- Start the Routing and Remote Access utility.
- Under Routing and Remote Access, right-click the server where you re-added the network interface, point to All Tasks, and then click Restart.
Method 3: Restart the ServerRestart the remote access server. The default route for the re-added network interface is added to the Windows routing table.
ID do Artigo: 816905 - Última Revisão: 7 de jan de 2008 - Revisão: 1