Device settings are hard to find in Windows XP


When you try to configure the direct memory access and programmed input/output (DMA/PIO) settings for a device on a Windows XP-based computer, the settings may not appear in the Properties dialog box for the device. Help does not provide the location of the settings.


This issue occurs because the DMA/PIO settings are configured for each controller instead of for each device.


To work around this issue, open Control Panel, and then follow these steps to configure the DMA/PIO settings for a controller:

  1. Click Start, click Run, type devmgmt.msc, and then click OK.
  2. Expand IDE ATA/ATAPI Controllers.
  3. Right-click the controller that you want to configure DMA/PIO settings for, and then click Properties.
  4. Click the Advanced Settings tab.
  5. In the Transfer Mode box, click either PIO Only or
    DMA if available.


Microsoft has confirmed that this is a problem in the Microsoft products that are listed in the "Applies to" section.

ID articol: 310751 - Ultima examinare: 23 oct. 2008 - Revizie: 1