In either case, the TCP/IP routing table will have multiple default routes listed (to view the routing table, type "ROUTE PRINT" from the command prompt). The route most likely to be used is the default gateway for the primary NIC that is bound to TCP/IP, but this is not always the case. If the Transmission Control Protocol (TCP) session on the active default gateway times out, TCP can switch to the next default gateway. This can present a problem depending on your network configuration.
It is not recommended to have multiple adapters configured on the same network (it may even create more overhead). For more information on TCP/IP behavior when multiple adapters are configured on the same network, please see the following article in the Microsoft Knowledge Base:
A common use of multiple default gateways is to configure a backup gateway in the event of a failure of the primary gateway (router). This backup gateway is used by dead gateway detection, and is only triggered with TCP or connection-oriented traffic. Utilities like PING cannot force the default gateway to switch, because these utilities use User Datagram Protocol (UDP) and Internet Control Message Protocol (ICMP).
For additional information, please see the following articles in the Microsoft Knowledge Base:
The default gateway is used only for traffic that needs to go to a network for which the server has no route. There is only one default gateway active for a computer at a time. You should generally configure the default gateway on the most complex network, and leave the field blank on the other adapter. However, if fault tolerance is desired, choose one of the following:
- If multiple routers are available on the same subnet, configure one (or more) default gateways on the same network adapter. This allows you to know which one is actually the primary. Leave all other adapters' default gateway configuration blank. -or-
- If the adapters on the multihomed computer are on disjoint networks (subnets that are not connected by a router), configure one (or more) default gateways on the same network adapter and use static routes for the remote networks that are reached through the network adapter with no default gateway. -or-
- Use a Routing Information Protocol (RIP) listener by enabling silent RIP and broadcasting available default routes with unique costs. The preferred default gateway can be the one advertised with the lowest cost. For more information, please see the following article in the Microsoft Knowledge Base:169161 Registry Parameters for RIP for IP Version 1
- The simplest way to control the ordering of default gateways is to add only a single default gateway through the TCP/IP properties in Control Panel and add any additional gateways using the command line utility Route.exe. By providing a unique cost for each gateway, the ordering of the gateways can be easily determined.
Номер статьи: 157025 — последний просмотр: 16 дек. 2009 г. — редакция: 1