FIX: An exception occurs or an application hangs when you sub-class a WinForms control in Windows Embedded Compact 2013

Introduction

This article describes an issue that occurs when you sub-class a WinForms control in Windows Embedded Compact 2013. An update is available to resolve this issue. Before you install this update, all previously issued updates for this product must be installed.

Symptoms

You have a .NET Compact Framework application on a device that has the September 2014 update for Windows Embedded Compact 2013 installed. If the device is ARM-based, and you sub-class a WinForms control, this triggers an exception or causes the application to hang.

Software update information

Download information

Windows Embedded Compact 2013 Monthly Update (October 2015) is now available from Microsoft. To download this Windows Embedded Compact 2013 monthly update, go to Microsoft OEM Online or MyOEM.

Prerequisites

This update is supported only if all previously issued updates for this product have also been installed.

Restart requirement

After you apply this update, you must perform a clean build of the whole platform. To do this, use one of the following methods:
  • On the Build menu, click Clean Solution, and then click Build Solution.
  • On the Build menu, click Rebuild Solution.
You do not have to restart the computer after you apply this software update.

Update replacement information

This update does not replace any other updates.

File information

Status

Microsoft has confirmed that this is a problem in the Microsoft products that are listed in the "Applies to" section.

References

Learn about the terminology that Microsoft uses to describe software updates.
Vlastnosti

ID článku: 3109332 – Posledná kontrola: 17. 11. 2015 – Revízia: 1

Pripomienky