Err Msg Using NET USE: System Error 1130 Has Occurred

Zavrnitev odgovornosti za umaknjeno vsebino KB

Ta članek govori o izdelkih, za katere Microsoft ne ponuja več podpore. Zato je ta članek na voljo »tak, kot je«, in ne bo več posodobljen.


When you use the NET USE command to connect to computer running Windows NT, the following error message appears:

System Error 1130 has occurred.
Not enough server storage is available to process this command.

In some cases the following text is written to the Event Viewer system log:

The server was unable to perform an operation due to a shortage of
available resources.

0000: 000c0000 005c0001 00000000 c00007d1
0010: 00000000 c000009a 00000000 00000000
0020: 00000000 00000000 000007d2 0000000b
0030: 0000003c


To correct this problem:
WARNING: Using Registry Editor incorrectly can cause serious, system-wide problems that may require you to reinstall Windows NT to correct them. Microsoft cannot guarantee that any problems resulting from the use of Registry Editor can be solved. Use this tool at your own risk.
  1. Run Registry Editor (REGEDT32.EXE).
  2. From the HKEY_LOCAL_MACHINE subtree, go to the following key:
  3. From the Edit menu, choose Add Value.
  4. Use the following values:
    Value Name: MinFreeConnections
    Data Type: REG_DWORD
    Decimal: 5
  5. Close Registry Editor.
  6. Run Control Panel and choose Network.
  7. Under Installed Network Software, highlight Server and then choose Configure.
  8. Under Optimization, select Maximize Throughput for File Sharing and then choose OK.
  9. Either shutdown and restart Windows NT, or from a command prompt, type the following two commands (pressing ENTER after each line):
    net stop server
    net start server

ID članka: 124357 – Zadnji pregled: 31. okt. 2006 – Revizija: 1

Povratne informacije