- You deploy a Dynamic Host Configuration Protocol (DHCP) failover by using a server that is running Windows Server 2012.
- In this environment, you deploy a pair of active-active (duplicate) DHCP relay agents.
- DHCP snooping and Dynamic ARP Inspection (DAI) are enabled on network devices, such as switches.
- Prevent duplicate DHCP requests. To do this, use one of the following options:
- Remove the second DHCP relay agent.
- Operate the DHCP relay agents in an active-passive mode. To do this, use virtual router groups if your router redundancy protocol is HSRP
- Configure DAI so that it honors the first DHCP lease duration value (whenever possible).
- If DAI cannot be configured to honor the first lease duration value, turn off or remove the DAI feature that is causing the conflict.
- Do not use DHCP failover in combination with two relay agents and DAI on the switches.
In a typical VRRP configuration that uses one IP address, one router is designated as the “active” device and the other one is set to "standby" mode. A heartbeat is exchanged between the routers. If the active router does not respond, the standby router takes over the shared IP address.
DHCP snooping enables a switch device to inspect DHCP traffic and to track which IP addresses are assigned to which host switch ports. This information can be useful to DAI. As soon as the DHCP lease duration expires, the traffic information is removed from the device database. A DAI-enabled switch will then block the ports.
A DHCP failover on a Windows Server 2012 server cannot guarantee consistent lease duration for duplicated DHCP requests. This behavior is by design. This is because a DHCP server may issue either a Maximum Client Lead Time (MCLT) or Scope lease duration value, depending on the following circumstances:
- Upon receiving the first request, the DHCP server sends an ACK that includes an MCLT lease duration value before it tries to synchronize with its partner. This is also known as a Lazy Update.
- If the sync response arrives before the duplicated request, the DHCP server considers its partner to be up-to-date. It then sends an ACK that includes the Scope lease duration value. This is the desired behavior.
- If the duplicate request arrives before the sync response, the race condition that is described in the "Cause" section occurs. In this case, the DHCP server considers its partner to be out-of-sync. This causes the second ACK to use the MCLT lease duration value.
- The DHCP transaction ID is a way for the client to relate a sent message with a received message. The RFC does not imply that the server should be dropping messages based on transaction ID.
- At this time, we believe that a design change is not warranted, based upon the following definition of a transaction ID that is provided in RFC 2131:xid 4
Transaction ID, a random number chosen by the client, used by the client and server to associate messages and responses between a client and a server.
ID članka: 2978225 - Poslednji pregled: 15.07.2014. - Verzija: 1