DirectX: Direct3d Acceleration Test Failed at Step 5

Ansvarsfriskrivning för KB-innehåll som inte uppdateras

Den här artikeln skrevs om produkter som Microsoft inte längre erbjuder support för. Därför erbjuds denna artikel "i befintligt skick" och kommer inte att uppdateras.

Symptoms

When you use the Microsoft DirectX Diagnostic Tool and run the Direct3D test, you may receive the following error message:
failure at step 5 (get device caps): hresult = 0x8876086a 3-d not available

Cause

This issue occurs because the Direct3D settings indicate that Direct3D is enabled, when in fact it is disabled.

Resolution

To resolve this issue, follow these steps:
  1. If the DirectX Diagnostic Tool is not already open, follow these steps:
    1. Click Start, and then click
      Run.
    2. In the Open box type
      DXdiag, then click OK.
  2. Click the Display tab.
  3. Verify that Direct3D Acceleration is listed as Enabled and the button to the right indicates
    Disable.
  4. Click Disable.
  5. When you receive the following warning, click
    OK:
    This will re-enable hardware acceleration of Direct3D for ALL display devices on your system.
  6. Verify that Direct3D Acceleration is still listed as Enabled and the button to the right indicates
    Disable.
  7. Click Disable
  8. When you receive the following warning, click
    OK:
    This will disable hardware acceleration of Direct3D for ALL display devices on your system.
Direct3d Acceleration now indicates that it is
Disabled and the button to the right now indicates
Enable. Click Enable one more time to properly start Direct3D Acceleration for your computer's display.

More Information

For additional information about the DirectX Diagnostic Tool, click the following article number to view the article in the Microsoft Knowledge Base:
190900 DirectX: Description of the DirectX Diagnostic Tool
Egenskaper

Artikel-id: 812491 – senaste granskning 27 jan. 2003 – revision: 1

Feedback