FIX: An update is available that enables you to obtain the status of test agents by using a command line in Visual Studio 2010


This article describes an update that enables you to obtain the status of all the test agents from the test controller computer by using a command line in Microsoft Visual Studio 2010. After you install this update, you can run the following command at the command prompt on the test controller computer to obtain the status of all the test agents:
testcontrollerconfig.exe status


Hotfix information

A supported hotfix is now available from Microsoft. However, it is intended to correct only the problem that this article describes. Apply it only to systems that are experiencing this specific problem.

To resolve this problem, contact Microsoft Customer Support Services to obtain the hotfix. For a complete list of Microsoft Customer Support Services telephone numbers and information about support costs, visit the following Microsoft website:Note In special cases, charges that are ordinarily incurred for support calls may be canceled if a Microsoft Support Professional determines that a specific update will resolve your problem. The usual support costs will apply to additional support questions and issues that do not qualify for the specific update in question.


To apply this hotfix, you must have Microsoft Visual Studio 2010 SP1 installed.

Restart requirement

You do not have to restart the computer after you install the hotfix if the affected files are not being used at the time of installation. We recommend that you close all Visual Studio 2010-related components before you install the hotfix.
File information


Microsoft has confirmed that this is a problem in the Microsoft products that are listed in the "Applies to" section.

รหัสบทความ: 2801364 - การตรวจสอบครั้งสุดท้าย: 6 มี.ค. 2013 - ฉบับแก้ไข: 1