XL2000: Sample Macro to Add or Place Object in Relation to a Range

View products that this article applies to.

This article was previously published under Q213607

SUMMARY

When you add objects to a worksheet using a Microsoft Visual Basic for Applications procedure, you need to specify the coordinates of the new object, in points, relative to the upper-left corner of cell A1 on a worksheet as well as the height and width of the object. Note, however, that you can add objects and make their position relative to a specified range by using the corresponding Top, Left, Width, and Height properties of the Range object.

NOTE: One point is approximately equal to 1/72 inch.

Back to the top

MORE INFORMATION

Microsoft provides programming examples for illustration only, without warranty either expressed or implied. This includes, but is not limited to, the implied warranties of merchantability or fitness for a particular purpose. This article assumes that you are familiar with the programming language that is being demonstrated and with the tools that are used to create and to debug procedures. Microsoft support engineers can help explain the functionality of a particular procedure, but they will not modify these examples to provide added functionality or construct procedures to meet your specific requirements.

Back to the top

Sample Visual Basic Procedures

The following sample macro adds a rectangle and centers it over the range C3:D4.

   Sub CenterObjectOverRange()
       'Set specified Range.
       Set MyRange = Range("C3:D4")
       'Add an object, specify the width and height you want the
       'object to be in points.
       Set MyObject = ActiveSheet.Rectangles.Add(0, 0, 20, 10)
       'Set top and left based on the selected range and
       'object size to center it.
       MyObject.Left = ((MyRange.Width / 2) + MyRange.Left) - _
           (MyObject.Width / 2)
       MyObject.Top = ((MyRange.Height / 2) + MyRange.Top) - _
           (MyObject.Height / 2)
   End Sub

The following sample macro adds a rectangle and sizes it to the outline of the range C3:D4.

   Sub AddObjectOnRange()
       'Set current Range.
       Set MyRange = Range("C3:D4")
       'Add object with Top, Left, Width, and Height based on MyRange.
       ActiveSheet.Rectangles.Add MyRange.Left, MyRange.Top, _
           MyRange.Width, MyRange.Height
   End Sub

Back to the top

REFERENCES

For more information about how to use the sample code in this article, click the article number below to view the article in the Microsoft Knowledge Base:

212536 (http://support.microsoft.com/kb/212536/EN-US/ ) OFF2000: How to Run Sample Code from Knowledge Base Articles

For additional information about getting help with Visual Basic for Applications, please click the article number below to view the article in the Microsoft Knowledge Base:

226118 (http://support.microsoft.com/kb/226118/EN-US/ ) OFF2000: Programming Resources for Visual Basic for Applications

Back to the top