Whatif switch does not work in the Set-MoveRequest or Resume-MoveRequest cmdlet in an Exchange Server 2010 environment

Article ID: 2694280 - View products that this article applies to.
Expand all | Collapse all

SYMPTOMS

Assume that you run the Set-MoveRequest or Resume-MoveRequest cmdlet together with the Whatif switch in Exchange Management Shell. However, the changes are applied to the object unexpectedly.

Note The Whatif switch simulates an action without applying any changes to an object.

CAUSE

This issue occurs because the ConfirmationMessage property in the Set-MoveRequest or Resume-MoveRequest cmdlet is not set correctly.

RESOLUTION

To resolve this issue, install the following update rollup:
2661854 Description of Update Rollup 2 for Exchange Server 2010 Service Pack 2

STATUS

Microsoft has confirmed that this is a problem in the Microsoft products that are listed in the "Applies to" section.

MORE INFORMATION

For more information about the Set-MoveRequest cmdlet, visit the following Microsoft website:
General information about the Set-MoveRequest cmdlet
For more information about the Resume-MoveRequest cmdlet, visit the following Microsoft website:
General information about the Resume-MoveRequest cmdlet

Properties

Article ID: 2694280 - Last Review: April 16, 2012 - Revision: 1.0
APPLIES TO
  • Microsoft Exchange Server 2010 Service Pack 2, when used with:
    • Microsoft Exchange Server 2010 Enterprise
    • Microsoft Exchange Server 2010 Standard
Keywords: 
kbqfe kbfix kbsurveynew kbexpertiseinter KB2694280

Give Feedback

 

Contact us for more help

Contact us for more help
Connect with Answer Desk for expert help.
Get more support from smallbusiness.support.microsoft.com