FIX: IP address of a virtual user changes when you run a load test if IP switching is enabled in Visual Studio 2010

Article translations Article translations
Article ID: 2769120 - View products that this article applies to.
Consider the following scenario:
  • You want to run a load test by using a test controller and test agents in Microsoft Visual Studio 2010.
  • You configure the test agents to enable IP switching.
  • You run the test.
In this scenario, the IP address of a single virtual user may change during a test.

Note The IP address changes are visible in the Internet Information Services logs.
Expand all | Collapse all

On This Page

Symptoms

Resolution

Hotfix information

A supported hotfix is now available from Microsoft. However, it is intended to correct only the problem that this article describes. Apply it only to systems that are experiencing this specific problem.

To resolve this problem, contact Microsoft Customer Support Services to obtain the hotfix. For a complete list of Microsoft Customer Support Services telephone numbers and information about support costs, visit the following Microsoft website:
http://support.microsoft.com/contactus/?ws=support
Note In special cases, charges that are ordinarily incurred for support calls may be canceled if a Microsoft Support Professional determines that a specific update will resolve your problem. The usual support costs will apply to additional support questions and issues that do not qualify for the specific update in question.

Prerequisites

To apply this hotfix, you must have Visual Studio 2010 SP1 installed.

Restart requirement

You do not have to restart the computer after you install the hotfix if the affected files are not being used. We recommend that you close all Visual Studio 2010-related components before you install the hotfix.

File information

The global version of this hotfix has the file attributes (or later file attributes) that are listed in the following table. The dates and times for these files are listed in Coordinated Universal Time (UTC). When you view the file information, it is converted to local time. To find the difference between UTC and local time, use the Time Zone tab in the Date and Time item in Control Panel.
Collapse this imageExpand this image
assets folding start collapsed
Collapse this tableExpand this table
File nameFile versionFile sizeDateTimePlatform
Microsoft.visualstudio.qualitytools.loadtest.dll10.0.40219.4411,108,70426-Feb-201300:57x86
Collapse this imageExpand this image
assets folding end collapsed

Status

Microsoft has confirmed that this is a problem in the Microsoft products that are listed in the "Applies to" section.

Properties

Article ID: 2769120 - Last Review: April 19, 2013 - Revision: 2.0
Applies to
  • Microsoft Visual Studio 2010 Service Pack 1
  • Microsoft Visual Studio 2010 Ultimate
  • Microsoft Visual Studio Team Agents 2010
Keywords: 
kbqfe kbhotfixserver kbfix kbsurveynew kbexpertiseadvanced KB2769120

Give Feedback

 

Contact us for more help

Contact us for more help
Connect with Answer Desk for expert help.
Get more support from smallbusiness.support.microsoft.com