FIX: ".NET Framework" or "500" error when you access an application that was published by Forefront Unified Access Gateway 2010 SP2

Article translations Article translations
Article ID: 2812665 - View products that this article applies to.
Expand all | Collapse all

Symptoms

Assume that an application is published by using Microsoft Forefront Unified Access Gateway 2010 Service Pack 2 (SP2). However, when you try to access the application, a .NET Framework error or a 500 error is returned.

Cause

This problem occurs when the application's URL contains a greater-than (>) or less-than (<) character.

Resolution

To resolve this problem, apply the service pack that is described in the following Microsoft Knowledge Base article:

2744025 Description of Forefront Unified Access Gateway 2010 Service Pack 3

Status

Microsoft has confirmed that this is a problem in the Microsoft products that are listed in the "Applies to" section.

References

For more information about software update terminology, click the following article number to view the article in the Microsoft Knowledge Base:
824684 Description of the standard terminology that is used to describe Microsoft software updates

Properties

Article ID: 2812665 - Last Review: February 20, 2013 - Revision: 1.0
Applies to
  • Microsoft Forefront Unified Access Gateway 2010 Service Pack 2
Keywords: 
kbqfe kbfix kbexpertiseinter kbsurveynew kbbug KB2812665

Give Feedback

 

Contact us for more help

Contact us for more help
Connect with Answer Desk for expert help.
Get more support from smallbusiness.support.microsoft.com