xHCI controller disappears after you rescan the hardware in Device Manager in Windows 8.1

Applies to: Windows Server 2012 R2 DatacenterWindows Server 2012 R2 StandardWindows Server 2012 R2 Essentials

This article describes an issue that occurs after you perform a hardware rescan in Windows 8.1. A hotfix is available to resolve this issue. The hotfix has a prerequisite.

Symptoms


This issue occurs when there is no device attached under the eXtensible Host Controller Interface (xHCI) downstream port on an AMD Carrizo APU-based computer.

Note This issue also occurs if the computer is resumed from hibernate mode.

Resolution


To resolve this issue, we have released a hotfix for Windows 8.1. Even though this issue has only been observed in Windows 8.1, the hotfix also applies to Windows Server 2012 R2 and Windows RT 8.1.

Hotfix information

A supported hotfix is available from Microsoft. However, this hotfix is intended to correct only the problem that is described in this article. Apply this hotfix only to systems that are experiencing this specific problem.

If the hotfix is available for download, there is a "Hotfix Download Available" section at the top of this Knowledge Base article. If this section does not appear, submit a request to Microsoft Customer Service and Support to obtain the hotfix.

Note If additional issues occur or if any troubleshooting is required, you might have to create a separate service request. The usual support costs will apply to additional support questions and issues that do not qualify for this specific hotfix. For a complete list of Microsoft Customer Service and Support telephone numbers or to create a separate service request, visit the following Microsoft website: Note The "Hotfix Download Available" form displays the languages for which the hotfix is available. If you do not see your language, it is because a hotfix is not available for that language.


Prerequisites

To apply this hotfix, you must have April 2014 update rollup for Windows RT 8.1, Windows 8.1, and Windows Server 2012 R2 (2919355) installed in Windows 8.1 or Windows Server 2012 R2.

Registry information

To use the hotfix in this package, you do not have to make any changes to the registry.

Restart requirement

You may have to restart the computer after you apply this hotfix.

Hotfix replacement information

This hotfix does not replace a previously released hotfix.

Status


Microsoft has confirmed that this is a problem in the Microsoft products that are listed in the "Applies to" section.

References


See the terminology that Microsoft uses to describe software updates.

Third-party information disclaimer
The third-party products that this article discusses are manufactured by companies that are independent of Microsoft. Microsoft makes no warranty, implied or otherwise, about the performance or reliability of these products.