FIX: EDIFACT message is invalid when you use EDIFACT interchanges to send messages to partner in BizTalk Server

Symptoms
Assume that you are using EDIFACT interchanges to send messages to your partner in Microsoft BizTalk Server 2010 or 2013. You leave the UNB9 (Acknowledgment request) field in UNB Segment Definition Page (EDI Properties) of the Parties node in BizTalk Server Administrator Console as the default value.

Note The default value for the UNB9 (Acknowledgment request) field is 0 - ACK not required.

In this situation, you may receive an error message from your partner that says the EDIFACT message is invalid.
Resolution

Cumulative update information

This issue was first fixed in the following cumulative update of BizTalk Server:
Status
Microsoft has confirmed that this is a problem in the Microsoft products that are listed in the "Applies to" section.
References
For information about the service packs and cumulative update list for BizTalk Server, see KB 2555976: Service pack and cumulative update list for BizTalk Server.

For more information about BizTalk Server hotfixes, see KB 2003907: Information about BizTalk hotfixes and Service Pack support.
Properties

Article ID: 2875914 - Last Review: 10/10/2015 00:13:00 - Revision: 2.0

Microsoft BizTalk Server Branch 2010, Microsoft BizTalk Server Developer 2010, Microsoft BizTalk Server Enterprise 2010, Microsoft BizTalk Server Standard 2010, Microsoft BizTalk Server 2013 Branch, Microsoft BizTalk Server 2013 Developer, Microsoft BizTalk Server 2013 Enterprise, Microsoft BizTalk Server 2013 Standard

  • kbqfe kbfix kbsurveynew kbexpertiseadvanced KB2875914
Feedback