How to import an .sft file from the command line in SoftGrid Client

Article translations Article translations
Article ID: 930965 - View products that this article applies to.
Expand all | Collapse all

INTRODUCTION

This article describes how to import an .sft file from the command line in Microsoft SoftGrid Client.

MORE INFORMATION

All Sfttray.exe command-line options are case sensitive. These options include the application name. You can import an .sft file from the command line by using Sfttray.exe. Sfttray.exe accepts the following parameters for importing.
Collapse this tableExpand this table
CommandUsageDescription
/load/load "[path_of_osd]"This parameter specifies the .osd file.
/sftfile/sftfile "file://[path_of_sft]"This parameter specifies the .sft file to import.
The Sfttray.exe usage for importing an .sft file from the command line is as follows:
sfttray.exe /load <OSD> /sftfile <SFT>
Examples of this usage are as follows:
sfttray.exe /load "\\SGVAS\content\ea70.osd" /sftfile "file://\\SGVAS\content\ea70.sft"
sfttray.exe /load "E:\ea70.osd" /sftfile "file://E:\ea70.sft"
The user can start the application only after the user successfully authenticates against the SoftGrid Server. If the SoftGrid Client is disconnected from the SoftGrid Server, the application will start if the user previously authenticated against the SoftGrid Server and if the Minimal Disconnected Operation (MDO) time-out interval has not elapsed.

For more information about Sfttray.exe command-line options, click the following article number to view the article in the Microsoft Knowledge Base:
930964 SFTTRAY 3.x command-line options

Properties

Article ID: 930965 - Last Review: April 18, 2007 - Revision: 2.0
APPLIES TO
  • Microsoft SoftGrid for Terminal Services
  • Microsoft SoftGrid for Windows Desktops
Keywords: 
kbexpertiseinter kbhowto KB930965

Give Feedback

 

Contact us for more help

Contact us for more help
Connect with Answer Desk for expert help.
Get more support from smallbusiness.support.microsoft.com