"SUWIN General Protection Fault" Error Messages During Windows 95 or Windows 98 Setup

Article translations Article translations
Article ID: 224836 - View products that this article applies to.
This article was previously published under Q224836
If this article does not describe the error message that you are receiving, view the following Microsoft Knowledge Base article to view more articles that describe error messages:
315854 Windows 98 and Windows Me Error Message Resource Center
Expand all | Collapse all

SYMPTOMS

When you try to install Windows 95 or Windows 98 in a new folder or a clean hard disk, you may receive one or more of the following error messages:
SUWIN
An error has occurred in your application. If you choose ignore you should save your work in a new file. If you choose close, your application will terminate.
-or-
SUWIN caused a general protection fault in module SETUPX.DLL
-or-
SUWIN caused a general protection fault in module KRNL386.EXE

CAUSE

This behavior can occur when any of the following conditions exist:
  • There are incorrect basic input/output system (BIOS) settings for a built-in peripheral device on your motherboard (for example, cache settings, CPU timing, hard disks, and so on).
  • Your computer has bad or mismatched random access memory (RAM) or cache (for example, if you are using EDO and non-EDO RAM, or you are using different RAM speeds).
  • The motherboard in your computer is not working properly.

RESOLUTION

To work around this behavior, try to slow down your computer by changing the BIOS settings. For information about how to change these settings, consult the documentation that came with your computer or contact the hardware manufacturer.

WARNING: If you change the BIOS settings for your computer incorrectly, serious problems can occur.

NOTE: Make the following changes, one at a time. After each change, save the setting, quit the BIOS, and then try to run Setup. If one step does not resolve the problem, try the next step, and so on.
  1. Modify the bus mastering setting.
  2. Modify the externalor internal cache setting.
  3. Modify your RAM setting.
  4. Modify other settings that are specific to your BIOS and that contribute to the speed at which your computer runs.
  5. Disable the Level 1 and Level 2 cache from the BIOS Setup tool for the duration of Setup.
  6. Disable the Ultra DMA setting (if applicable) for the hard disk or CD-ROM drive. For information about how to change these settings, consult the documentation that is included with your computer.
If the error message still occurs after you perform these steps, the hardware may be damaged. Contact your hardware manufacturer for assistance.

MORE INFORMATION

For additional information about SUWIN error messages, click the article numbers below to view the articles in the Microsoft Knowledge Base:
129971 "SU" Error Message List for Windows 95, Windows 98, and Windows Me Setup
187580 SUWIN Warning SU0167 Message During Windows 98 Setup
188107 Suwin Error in Setupx.dll During Windows 95/98 Setup
124177 Application Error: SUWIN Caused an Illegal Instruction
135162 GP Fault After End User License Agreement During Setup
136415 You receive a "SUWIN caused a General Protection Fault in module SUWIN.EXE at 0006:6EB8" error message when you are installing Windows 95
187268 SUWIN Error in Pidgen.dll During Windows 98 Setup
232963 Err Msg: Suwin.exe Caused an Invalid Page Fault in Setupx.dll

Properties

Article ID: 224836 - Last Review: January 24, 2007 - Revision: 2.2
APPLIES TO
  • Microsoft Windows 98 Standard Edition
  • Microsoft Windows 95
  • Microsoft Windows 98 Second Edition
Keywords: 
kberrmsg kbgpf kbhardware kbprb kbsetup KB224836

Give Feedback

 

Contact us for more help

Contact us for more help
Connect with Answer Desk for expert help.
Get more support from smallbusiness.support.microsoft.com