How to use System files to create a boot disk to guard against being unable to start Windows XP

Article ID: 314079 - View products that this article applies to.
This article was previously published under Q314079

To continue receiving security updates for Windows, make sure you're running Windows XP with Service Pack 3 (SP3). For more information, refer to this Microsoft web page: Support is ending for some versions of Windows
(http://windows.microsoft.com/en-us/windows/help/end-support-windows-xp-sp2-windows-vista-without-service-packs)

For a Microsoft Windows 2000 version of this article, see 101668
(http://support.microsoft.com/kb/101668/ )
.
Expand all | Collapse all

INTRODUCTION

If your computer uses an Intel x86-based processor, and the startup record for the active partition or files that you must have to start Windows become corrupted, you may not be able to start your computer. This article describes how to create a startup disk. With a startup disk, you can start your computer if the startup record becomes corrupted.

MORE INFORMATION

Create a Windows startup disk when you first install Windows on the computer. This disk is different from an MS-DOS startup disk. Unlike MS-DOS, the whole Windows operating system cannot fit on one floppy disk. A Windows startup disk contains only the files that you must have to start the operating system with the remainder of the Windows system files installed on the hard disk drive. To create the startup disk, follow these steps:
  1. Insert a blank floppy disk in drive A, and then format the disk by using Windows XP.
  2. From the root folder of the system partition of your hard disk drive (for example, C:\-), copy the following files to the floppy disk:
    Boot.ini
    NTLDR
    Ntdetect.com
    You may have to remove the hidden, system, and read-only attributes from the files.
  3. Restore the hidden, system, and read-only attributes to the files on your hard disk if you removed these attributes.
  4. If the Bootsect.dos file or the Ntbootdd.sys file resides in the system partition, repeat steps 2 through 4 to copy these files to the boot disk.
If you format a floppy disk in Windows XP, the startup record points to the NTLDR file. When NTLDR runs, it loads the available operating system selections from the Boot.ini file. If you select Windows, NTLDR runs Ntdetect.com, and then passes control to Osloader.exe. If you select MS-DOS or OS/2, NTLDR loads Bootsect.dos.

Properties

Article ID: 314079 - Last Review: June 23, 2005 - Revision: 2.5
APPLIES TO
  • Microsoft Windows XP Home Edition
  • Microsoft Windows XP Professional
Keywords: 
kbacwsurvey kbhowto kbenv kbinfo kbsetup kbusage KB314079
Back to the top | Give Feedback

Give Feedback

 
Back to the topBack to the top