Article ID: 115333 - View products that this article applies to.
This article was previously published under Q115333
This article has been archived. It is offered "as is" and will no longer be updated.
BUG #: 10215 (4.21a) BUG #: 16652 (SQLBUG_65) BUG #: 57903 (SQLBUG_70) BUG #: 56127 (SHILOH)
If a stored procedure or view depends on a table that has been dropped, sysdepends will continue referencing the old ID of the table as a dependent, even if this ID does not exist any more. As a result, sp_depends will not show the correct object dependency.
Drop and recreate the stored procedure or view. The entries for sysdepends will be properly recreated.
Microsoft has confirmed this to be a problem in the Microsoft products listed at the beginning of this article. We are researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available.
The following is an example of the problem. First, create the table and procedure referencing that table.
name id ----------------------------- ---------- testx 464004684 procx 480004741
Now drop the table, and recreate it using the same name. Then new object id.
drop table testx go create table testx (c int) go select id from sysobjects where name = "testx"
id ----------- 512004855
A query against sysdepends shows that the dependent object id is not updated.
select id, depid from sysdepends where id = 480004741
id depid ---------- ---------- 480004741 464004684
Article ID: 115333 - Last Review: February 28, 2014 - Revision: 3.3