How to Disable a Service or Device that Prevents Windows from Booting

Article ID: 244905 - View products that this article applies to.
This article was previously published under Q244905
Notice
This article applies to Windows 2000. Support for Windows 2000 ends on July 13, 2010. The Windows 2000 End-of-Support Solution Center
(http://support.microsoft.com/?scid=http%3a%2f%2fsupport.microsoft.com%2fwin2000)
is a starting point for planning your migration strategy from Windows 2000. For more information see the Microsoft Support Lifecycle Policy
(http://support.microsoft.com/lifecycle/)
.
Expand all | Collapse all

SYMPTOMS

If a service or device driver is started automatically and is incompatible with the current version of Windows, the service or device driver may not allow Windows to remain running long enough for you to shut down the service or disable the outdated device driver.
Back to the top | Give Feedback

CAUSE

This behavior can occur if hardware or software is installed that installs a device or service that is incompatible with the current version of Windows.
Back to the top | Give Feedback

RESOLUTION

To resolve this issue, start Recovery Console and log on to the computer using the following steps:
  1. Start your computer with the Windows boot disks, or with the Windows CD-ROM if your computer supports booting from the CD-ROM drive.
  2. When the Welcome to Setup dialog box is displayed, press R to repair, and then press C to start Recovery Console.
  3. Choose to install Windows and log on to your computer with the Administrator account.
  4. From the %SystemRoot%\System32 folder at the command prompt, type listsvc, and then press ENTER.
  5. Locate the service or driver that is causing the problem in the list that is provided.

    NOTE: Selecting the wrong service or device could cause further problems.
  6. Type disable servicename (where servicename is the name of the service), and then press ENTER.

    NOTE: The disable command prints the old start_type of the service before resetting it to SERVICE_DISABLED. You should record the old start_type, in case you need to re-enable the service.
  7. Type exit, and the computer restarts automatically. Allow the computer to boot normally.
Back to the top | Give Feedback

MORE INFORMATION

For additional information about installing or using the Recover Console, click the article number below to view the article in the Microsoft Knowledge Base:
229716
(http://support.microsoft.com/kb/229716/EN-US/ )
Description of the Windows 2000 Recovery Console
Back to the top | Give Feedback

Properties

Article ID: 244905 - Last Review: February 28, 2007 - Revision: 3.5
APPLIES TO
  • Microsoft Windows 2000 Server
  • Microsoft Windows 2000 Advanced Server
  • Microsoft Windows 2000 Professional Edition
  • Microsoft Windows 2000 Datacenter Server
Keywords: 
kbenv kbprb KB244905
Back to the top | Give Feedback

Give Feedback

 
Back to the topBack to the top