Select the product you need help with
- Internet Explorer
- Windows Phone
- More products
Connecting a hard disk drive in slave only mode leads to system halt during resume from standby
Article ID: 330100 - View products that this article applies to.
This article was previously published under Q330100
A computer that is running Microsoft Windows XP or a later operating system stops responding during resume from standby, and you receive the following KERNEL_DATA_INPAGE_ERROR stop error message:
Note Parameter2, Parameter3, and Parameter4 in the stop error may vary.
0x000000F4 (0x00000003, Parameter2, Parameter3, Parameter4)
This problem occurs on a computer in which Windows XP or a later operating system is installed on a hard disk that is configured as a subordinate and no other device is connected to the same IDE controller channel (primary or secondary).
This behavior may occur when you use Windows XP or a later operating system with some motherboards. Microsoft is researching this problem and will post more information in this article when the information becomes available.
To resolve this behavior, use one of the following methods:
Steps to reproduce the behavior
Article ID: 330100 - Last Review: September 22, 2011 - Revision: 7.0