Stop error 0x0000003B when you try to connect to a server by using Remote Desktop Protocol in Windows 7 or Windows Server 2008 R2

S’applique à : Windows Server 2008 R2 DatacenterWindows Server 2008 R2 EnterpriseWindows Server 2008 R2 Foundation

Not sure if this is the right fix? We've added this issue to our memory dump diagnostic which can confirm.

Symptoms


Consider the following scenario:
  • You have a computer that is running Windows 7 or Windows Server 2008 R2.
  • You use Remote Desktop Protocol (RDP) to connect to a server that is running Remote Desktop Services.

In this scenario, the server crashes, and you receive a Stop error 0x0000003B.

Resolution


Hotfix information

A supported hotfix is available from Microsoft Support. However, this hotfix is intended to correct only the problem that is described in this article. Apply this hotfix only to systems that are experiencing the problem described in this article. This hotfix might receive additional testing. Therefore, if you are not severely affected by this problem, we recommend that you wait for the next software update that contains this hotfix.

If the hotfix is available for download, there is a "Hotfix download available" section at the top of this Knowledge Base article. If this section does not appear, contact Microsoft Customer Service and Support to obtain the hotfix.

Note If additional issues occur or if any troubleshooting is required, you might have to create a separate service request. The usual support costs will apply to additional support questions and issues that do not qualify for this specific hotfix. For a complete list of Microsoft Customer Service and Support telephone numbers or to create a separate service request, go to the following Microsoft website: Note The "Hotfix download available" form displays the languages for which the hotfix is available. If you do not see your language, it is because a hotfix is not available for that language.

Prerequisites

To apply this hotfix, you must have Service Pack 1 for Windows 7 or Windows Server 2008 R2 installed.

Restart requirement

You must restart the computer after you apply this hotfix.

Hotfix replacement information

This hotfix does not replace any previously released hotfix.

Status


Microsoft has confirmed that this is a problem in the Microsoft products that are listed in the "Applies to" section.

References


Learn about the terminology that Microsoft uses to describe software updates.