You configure a Microsoft System Center 2012 Configuration Manager Service Pack 1 (SP1) primary site and a System Center 2012 Configuration Manager SP1 secondary site.
You create a package on the primary site.
You distribute the package to the distribution point of the secondary site.
You validate the package on the distribution point of the secondary site after the content status reads Success.
You verify that the content status reads Success after the validation is completed.
You right-click the package and then select Update distribution point.
In this scenario, the content status is stuck in In progress - Waiting for Content status instead of Success status.
A supported hotfix is available from Microsoft. However, this hotfix is intended to correct only the problem that is described in this article. Apply this hotfix only to systems that are experiencing the problem described in this article. This hotfix might receive additional testing. Therefore, if you are not severely affected by this problem, we recommend that you wait for the next software update that contains this hotfix.
If the hotfix is available for download, there is a "Hotfix download available" section at the top of this Knowledge Base article. If this section does not appear, contact Microsoft Customer Service and Support to obtain the hotfix.
Note If additional issues occur or if any troubleshooting is required, you might have to create a separate service request. The usual support costs will apply to additional support questions and issues that do not qualify for this specific hotfix. For a complete list of Microsoft Customer Service and Support telephone numbers or to create a separate service request, go to the following Microsoft website:
You do not have to restart the computer after you apply this hotfix.
Note We recommend that you close the Configuration Manager Administration Console before you install this hotfix package.
Hotfix replacement information
This hotfix does not replace a previously released hotfix.
The English version of this hotfix has the file attributes (or later file attributes) that are listed in the following table. The dates and times for these files are listed in Coordinated Universal Time (UTC). When you view the file information, it is converted to local time. To find the difference between UTC and local time, use the Time Zone tab in the Date and Time item in Control Panel.
Microsoft has confirmed that this is a problem in the Microsoft products that are listed in the "Applies to" section.